![]() ![]() And my car doesn’t even seem to be registering the EKPM3 module. However, I should note that whenever I was in INPA, I clicked on f2 (Ident) before I went to NCSEXPERT. So, I’m pretty sure I did it all correctly. And followed his same steps, step-by-step. But, I found a video online of a guy doing this exact thing to his 335i. Idk what else todo… Or, if maybe I missed something/left a step out… I’m pretty new to all of this. (I’ve attached a picture of the error message) Made sure that the job was “SG_Codieren”.īut, I received an error message. ![]() Then, I clicked Process ECU and selected CAS module. Then, I read the vin and selected my chassis and clicked “back”. Then, opened up NCSEXPERT and loaded the Revtors profile. I opened up INPA, to make sure that I had a good connection to the car. I recently bought a new EKPM for my 2007 328i… Because my old one wasn’t putting out any power to the fuel pump. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |